RLC4DEMO.EXE is a MS-DOS program that simulates controlling the RLC-4
from its serial port with a computer or serial terminal.  Due to the
memory limitations of PCs running MS-DOS and the lack of actual
controller hardware, some features are not supported.  The program sends
CW command responses out of the PC speaker, but due to the low
resolution of the timer that is used, the CW sounds rough.  This problem
is not present on the actual controller.  Note that the CW can be turned
off by entering C045*0 and turned back on with C045*01 as shown in the
example below:

RLC-4 Reset
Software Version 1.47
Copyright (C) Link Communications, Inc. 1995

RE-INITIALIZING...

Reset Event 
DTMF>C009
         TX
RX   1  2  3  4
1    .  .  .  .  
2    .  .  .  .  
3    .  .  .  .  
4    .  .  .  .  
DTMF>C000*12
Port 1 connected to Port 2
DTMF>C009
         TX
RX   1  2  3  4
1    .  x  .  .  
2    x  .  .  .  
3    .  .  .  .  
4    .  .  .  .  
DTMF>C045*0
The serial message routing variable is: none
DTMF>C009
         TX
RX   1  2  3  4
1    .  x  .  .  
2    x  .  .  .  
3    .  .  .  .  
4    .  .  .  .  
DTMF>C045*01
The serial message routing variable is: 1  
DTMF>C009
         TX
RX   1  2  3  4
1    .  x  .  .  
2    x  .  .  .  
3    .  .  .  .  
4    .  .  .  .  
DTMF>C037
Can't simulate remote reset - exiting

Please email, fax or call me if you have any questions,
Steve Strobel
linkcomm@netins.net
(406) 482-7547 fax
(406) 482-7515 voice